|
|
|
 The world isn't made out of Nerf, you will get scrapes and bruses, but you will get back up and continue on. If you watch out you can avoid the sharp edges.
- Joe Matt [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
LabVIEW Training for FRC Teams
I'm holding 2 LabVIEW training sessions this week at National Instruments, for those in the Austin area (or who want to drive to Austin). We'll be covering mostly the information in our "Learning LabVIEW in 3 Hours" training course that is offered for free online, but the benefit here is one-on-one interaction with National Instruments Applications Engineers and LabVIEW RT Developer (me). I know, this is incredibly short notice, and I'm open to holding this again at a later time if there is need/demand.
Here's the info: Venue: National Instruments Date: July 22 and July 25, 2008 Time: 1:00pm to 4:00pm Location: Building B, 2nd Floor, Training Room 2 Contact/RSVP: danny.diaz[at]ni.com The course is limited to 13 people per session (the 22nd and 25th are duplicates), so please RSVP with me at the e-mail address listed above. If you cannot make the session, please check out the following document: https://lumen.ni.com/nicif/us/academ.../content.xhtml -Danny 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LabVIEW Robot Modeler / Simulation Kit for FRC Teams | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 4 | 17-10-2008 13:32 |
| **FIRST EMAIL**/Special Early Offers for 2007 FRC Teams | Rich Wong | FIRST E-Mail Blast Archive | 0 | 02-11-2006 17:16 |
| Special Autodesk Inventor Video Training offer for teams! | Rich Kressly | Inventor | 5 | 11-08-2005 14:49 |
| For FRC want-to-be Teams | Rich Wong | Starting New Teams | 1 | 18-07-2003 13:30 |
Threaded Mode