|
|
|
 teams that REALLY deserve to win will find ways to overcome a marginal officiating decision. Also, teams that REALLY deserved to win will try not to put themselves in that position. - Chris Hibner [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Vibrations during CNC
what i do is just not cut all the way leave a 64 there to hole it then just punch the part out later and file the burs off
|
|
#2
16-10-2008, 14:31
|
||||
|
||||
|
Re: Vibrations during CNC
That sounds like a good idea with the C-clamp. I would just make sure it was properly clamped/supported.
|
|
#3
20-10-2008, 09:49
|
||||
|
||||
|
Re: Vibrations during CNC
End of Weekend update:
A brand new bit was put on the CNC and we learned that the spindle speed had to be manually adjusted. So after some fine tuning of the machine and refinement of the drawings, the machine cut the rectangles in under 5 minutes each. We wound up bolting the middle rectangle on the opposite end from the final cut and it worked out beautifully. Pretty sweet! Now we're off to scavenge parts off of an older bot to fix the '08 bot's problems. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intelitek CNC Motion - Virtual CNC Machines | Kingofl337 | Programming | 0 | 19-03-2008 11:29 |
| CNC Machines | DEAL234 | Technical Discussion | 17 | 07-02-2007 16:30 |
| CNC Options? | Andrew Blair | Technical Discussion | 5 | 06-02-2006 18:12 |
| Centroid CNC | team222badbrad | Technical Discussion | 25 | 09-11-2005 20:36 |
| To CNC? Or not to CNC? | phrontist | General Forum | 21 | 26-03-2004 13:45 |
Hybrid Mode
