|
|
|
 Why is everyone on these boards so obsessed with Segways? - Tom Bottiglieri [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Why is everyone on these boards so obsessed with Segways? - Tom Bottiglieri [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
[FTC]: Problem with two controller setup in Labview
Greetings,
Team 35 is waist deep into our build and things have been going rather smoothly until we tried to put the drivebase control on one logitech controller and the arm control on the second. As soon as we put a second controller VI into labview and upload it into the brick, we get no response from the robot at all. Both controllers are dead. Has anyone else run into this problem? 
|
|
#2
11-11-2008, 19:21
|
||||
|
||||
|
Re: [FTC]: Problem with two controller setup in Labview
You have to download the two controller update for labview on the NI site.
http://zone.ni.com/devzone/cda/tut/p/id/7956 click the Dual Controller update.
|
|
#3
11-11-2008, 19:58
|
||||
|
||||
|
Re: [FTC]: Problem with two controller setup in Labview
Yep, we just found that on the website. thanks!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: First problem with FTC and LabView.....? | PhilBot | FIRST Tech Challenge | 5 | 07-11-2008 10:36 |
| [FTC]: FTC Servo-Motor Problem with Labview | dnhansen | FIRST Tech Challenge | 1 | 26-10-2008 00:43 |
| First problems with FTC and Labview | PhilBot | National Instruments LabVIEW and Data Acquisition | 0 | 10-09-2008 20:21 |
| problem with speed controller | gaby1367 | Electrical | 11 | 14-05-2007 22:16 |
| Problem with freezing frames in LabVIEW | pdc | LabView and Data Acquisition | 2 | 26-01-2006 01:34 |
Linear Mode
