Invetner 08 - Gears

hoosfoos1993 · #1 05-12-2008, 16:13

I've been working with Inventor 08 for a couple of months and I've found on the Design Accelerator that whenever I try to make a gear it comes out with a gear a completely different size than I thought was going to come out. Is there any way to fix that? If not is there anywhere I can download pre-made gears to use of various sizes?

AdamHeard · #2 05-12-2008, 16:33

SDP-SI and Firstcadlibrary are both places I go to for gears often.

SDP-SI sometimes only has a few teeth modeled, but usually some cuts and rotates will get you a complete gear.

vivek16 · #3 05-12-2008, 16:38

IGear from firstcadlibrary. You can edit some details to make it the gear you want. Here is a link: http://www.firstcadlibrary.com/drawi...r(English).zip

thanks, Vivek

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gears	Jack	3D Animation and Competition	7	08-07-2003 21:39
Gears	Thunder360	Technical Discussion	10	23-03-2003 11:33
Gears	Thunder360	Motors	2	17-03-2003 21:58
gears....?	archiver	2000	16	23-06-2002 22:58