|
|
|
 Isn't that, April showers bring Woodie Flowers? ;) - jgannon [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Isn't that, April showers bring Woodie Flowers? ;) - jgannon [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Labview 'Invert Flag' for motors
We were controlling the servos on our robot in an extremely simple test (based on the defualt example), and the sets of wheels (chained per side) spun in opposite directions. Hence, as we created the reference to the engines outside the main while, we added an invert flag to one of them. We could not observe any change. (Err... where not sure if they both switched, though.) When we set 'true' to the invert flag on both motors, nothing happened at all.
When both flags are false it works fine. Our engines our in the same slot and are of different PWMs. We send the same 127 nuetral (0-255) value to both motors from the graphical slider. Ah, and thanks for any help. If there is anything I could do to make this clearer, please let me know! Last edited by ksquared : 12-01-2009 at 21:31. Reason: Needed to give thanks 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview with Four Motors | brianc217 | General Forum | 3 | 04-01-2009 23:58 |
| Labview with Four Motors | brianc217 | NI LabVIEW | 0 | 04-01-2009 11:52 |
| Flag, Flag Holder vs Trackballs | Swampdude | Rules/Strategy | 29 | 09-03-2008 09:17 |
| Flag for MC at the Competitions | kjhobin | Regional Competitions | 12 | 24-02-2008 03:55 |
| Wave a Flag for our troops! | Alex Cormier | Chit-Chat | 3 | 25-03-2003 17:57 |
Linear Mode
