Driver Station Screen Fails on Connecton to Robot

nekng · #1 19-01-2009, 16:49

The display on my team's drive station shuts off when a wireless connection is established between it and the robot. We are running the updated image on the DS and on the robot we are running the updated default windriver code. Does any else have this problem?

nekng · #2 19-01-2009, 20:51

Actually, it is not just when the DS connects to the robot, it seems that the screen fails randomly from 10seconds-2minutes after boot. It is only the screen that fails, everything else keeps working.

Vikesrock · #3 19-01-2009, 21:11

Quote:

Originally Posted by nekng

Actually, it is not just when the DS connects to the robot, it seems that the screen fails randomly from 10seconds-2minutes after boot. It is only the screen that fails, everything else keeps working.

There have been reports of static discharge causing the screen to go out. Is your work area particularly dry? That could lead to frequent static discharges onto the DS.

nekng · #4 20-01-2009, 01:36

Quote:

Originally Posted by Vikesrock

There have been reports of static discharge causing the screen to go out. Is your work area particularly dry? That could lead to frequent static discharges onto the DS.

Not only is our work area really dry, but the floor is covered with carpet so that makes a lot of sense.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dead Driver Station?	tdeprince	FRC Control System	3	12-02-2009 12:14
Driver Station Login	Mr-Shutter	FRC Control System	2	12-01-2009 23:36
Driver Station Blank Screen, Anyone have the same problem?	LDavies562	FRC Control System	14	22-12-2008 19:34
Driver Station Setup??	Team 1708 Dave	Programming	9	19-12-2008 23:09
driver station doesn't see robot	nickmagus	Programming	4	29-11-2008 23:58