pic: Wheel to gear box flange

joeweber · #1 01-20-2009, 09:53 PM

groves · #2 01-20-2009, 09:59 PM

For teams that don't have the means to make this part (and have money to spend), it's available through andymark for $15 each. They also incorporate the keyway that you need.

meastman · #3 01-20-2009, 10:09 PM

Our team purchased this flange, and it is very helpful. Much better then machining our own part.

Devo1098 · #4 01-21-2009, 12:57 AM

Quote:

Originally Posted by groves

For teams that don't have the means to make this part (and have money to spend), it's available through andymark for $15 each. They also incorporate the keyway that you need.

keyway? great for power transmission, however, with the low friction this year, you really don't need more than a set screw jammed into the axle or key way cut, were even using a press fit on our sleeves

114Klaatu0x72 · #5 01-31-2009, 06:20 AM

Great minds think alike. Then we fight over the minor differences. But really, this seems to be a popular design this year

Cory · #6 01-31-2009, 06:34 AM

Quote:

Originally Posted by 114Klaatu0x72

Great minds think alike. Then we fight over the minor differences. But really, this seems to be a popular design this year

Did you mean...great minds think like Andy Baker and Mark Koors?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Track drive gear-box	sam shawe	Extra Discussion	5	12-05-2006 03:01 PM
pic: Team 229 Gear Box Teaser	Adrienne E.	Extra Discussion	9	01-15-2006 03:37 PM
pic: GEAR BOX with two speed	ericwittlich	Extra Discussion	6	07-19-2005 10:01 PM
pic: Our Gear Box	Victor_Mec	Extra Discussion	1	03-11-2005 09:35 AM
pic: 1382 Brazil - Gear box	tribotec_ca88	Robot Showcase	19	02-01-2005 09:37 PM