another festo problem

Team2883 · #1 28-01-2009, 23:25

We have the compressor working, the code working. The light comes on, on the silenoid, but does not fire. Any suggestions? Thank you again.

~ Fighting Rednecks ~

Trent B · #2 28-01-2009, 23:31

Do you have air volume tanks? Sorry I asked

Post a picture of your pneumatics setup.

How is your solenoid connected?

Have you tested output with volt meter

Team2883 · #3 29-01-2009, 00:09

We were able to figure it out...we had the connections mixed up on the solenoid

~Fighting Rednecks~

Trent B · #4 29-01-2009, 23:47

Quote:

Originally Posted by Team2883

We were able to figure it out...we had the connections mixed up on the solenoid

~Fighting Rednecks~

That always results in a lot of frustration, good to hear you fixed it.

nevereverregret · #5 11-02-2009, 20:22

do you hear the click that means the vaulves are swiching?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Another IR Board Problem	C222	Electrical	2	13-01-2008 17:36
Festo	itay_ms	Electrical	3	30-01-2007 09:08
Problem solved but now another question	Adam Y.	Programming	1	03-05-2006 08:54
Got it working now theres another problem!	cdennisxlx2	Programming	11	25-03-2006 21:58
121, another competition, another victory.	Greg Perkins	Off-Season Events	27	06-06-2002 23:13