|
|
|
 I enjoy the brainstorming that's going on here, you guys out think me most of the time. Keep it up. - fnsnet [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I enjoy the brainstorming that's going on here, you guys out think me most of the time. Keep it up. - fnsnet [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Driver station and battery fail to communicate
We have applied all updates to the driver station and cRIO and are running wireless. We had readings of the battery power with cRIO update v7, but not with cRIO v11. We have the jumper installed as per <R64> and the data sheets, sect 3.4. The rest of the robot runs fine though. The driver station reads "No comms." or 0 volts.
Last edited by Peter H : 05-02-2009 at 16:29. Reason: More info 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station S.O.S. | M. Gildner | Electrical | 15 | 28-11-2009 19:35 |
| Driver station only regognizes USB 1 and 2 | cvxdes | Programming | 14 | 05-02-2009 14:40 |
| Camera and driver station | viperred396 | General Forum | 8 | 05-02-2009 10:12 |
| Reading battery power on Driver station. | Digmaster | Electrical | 8 | 31-01-2009 20:09 |
| driver station and cRIO firmware update help | asianfez123 | FRC Control System | 1 | 16-01-2009 02:34 |
Hybrid Mode
