|
|
|
 Turning is overrated - Allison [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Turning is overrated - Allison [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
cRIO Imaging Tool HELP PLEASE!!!
i'm trying to connect to my cRIO but when i run the imaging tool it says that "no devices can be found" i've tried everything! the router, bridge and all other components of the robot are running fine, and the laptop is connected to the wireless signal. please help me! i don't know what else to do!
|
|
#2
05-02-2009, 19:42
|
||||
|
||||
|
Re: cRIO Imaging Tool HELP PLEASE!!!
Connect your cRio to your PC directly using a crossover cable, and set your IP address to 10.0.0.6 subnet 255.0.0.0. Then post your results.
BTW, i tried everything isn't very useful. If you had tried everything you would have fixed it.  Its much better to explain just what you have tried.
|
|
#3
08-02-2009, 22:44
|
||||
|
||||
|
Re: cRIO Imaging Tool HELP PLEASE!!!
Try check your IP first. If this is your first time updating your cRIO, IP address should be 10.0.0.2 with submask of 255.0.0.0
Connect your PC to Driver station. From there driver station should be connected to cRIO directly(I don't recommend using wireless connection when you are updating cRIO image.)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FRC cRIO Imaging Tool | furiousgeorge | Programming | 1 | 06-02-2009 09:52 |
| cRio Stand-alone Image Tool | Vikesrock | FRC Control System | 3 | 29-01-2009 19:38 |
| Need help to find a tool, kinda urgent | R.C. | Technical Discussion | 41 | 12-07-2008 14:44 |
| pic: please help us please mortals | CD47-Bot | Robot Showcase | 5 | 25-01-2004 11:03 |
| please help us, pretty please :) | archiver | 2001 | 0 | 24-06-2002 03:13 |
Hybrid Mode
