|
|
|
 *speaks into wristwatch* We've got a non-gracious professional here, get Woodie on the phone! - Ringo5tarr [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| *speaks into wristwatch* We've got a non-gracious professional here, get Woodie on the phone! - Ringo5tarr [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
How do we open a servo in the Begin.vi
 Hoe do we open a servo in the Begin.vi? We need FAST! Thanks! Also, if there is anything else we need to do i.e. setup the watchdog to run with the servo, then please let us know!Last edited by JeffatJITB : 07-02-2009 at 17:15. 
|
|
#2
07-02-2009, 21:01
|
|||
|
|||
|
Re: How do we open a servo in the Begin.vi
The main thing to do is to drop the Open into the Begin diagram. Then add the refnum to the typedef, go to the teleop or auto, grow the cluster, and wire to the servos.
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where do I begin to get the robot to move using the camera? | Ianuser | Programming | 10 | 16-02-2007 17:55 |
| Let the AZ Regional Begin! | WakeZero | Regional Competitions | 5 | 12-03-2004 00:18 |
| As the matches Begin | Boilerman31 | General Forum | 3 | 07-03-2003 12:19 |
| How do you set a speed limit on the servo | Fares | Programming | 6 | 01-01-2003 15:04 |
| How much do the servo cost? | Ken Leung | Motors | 2 | 14-09-2001 15:42 |
Linear Mode
