RE: USB ports not working

jblay · #1 07-02-2009, 18:30

Hi,

We are having issues with the USB ports on the Driver Station. Basically, ports 3 and 4 are not giving us any data. We updated the firmware to the 1-22-09c version, and then only port 1 was operational. We have tried almost every possible method of troubleshooting, but we have no idea of what is wrong. Does anyone here have similar issues/ possible solutions/suggestions? We are desperate!

Thanks,
Team 694

Darkcrosbone · #2 07-02-2009, 18:44

You must use the USB ports in sequential order, so using ports 3 & 4 while nothing is pluged into 1 and 2 wont work, that is how it works with our Driver Station

jblay · #3 07-02-2009, 19:12

Yea, we had the joysticks plugged in sequentially, but it still didn't work.

Thanks,
Team 694

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
driver station does not recognize usb 3 or 4...	aksharma	Technical Discussion	0	07-02-2009 12:57
IR Board Not Working (But NOT Fried)	itsme	Electrical	2	18-02-2008 06:11
Not enought Serial ports	FIRSTMa2104	Programming	10	05-02-2008 11:40
IFIloader and usb converter does not work	jasonpeinko	Control System	9	09-01-2008 20:54
USB to Serial -- Working Device Found!	Eko	Programming	10	23-02-2004 12:56