|
|
|
 This our big chance to spread the word and change the culture, let's not waste it. So in the words of one Leroy Jenkins, "Time's up, let's do this." - Frenchie461 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This our big chance to spread the word and change the culture, let's not waste it. So in the words of one Leroy Jenkins, "Time's up, let's do this." - Frenchie461 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
drivers station digital input trouble
on our control board, we have several switches that i have wired to digital inputs on the drivers station console. in labview i have made an indicator light that should light when the circuit is open. when the circuit is closed, the light goes off as it should, but when it is open, it flashes on and off. even when i connect a pwm cable with NOTHING on the opposite end, the light still continues to flash. any ideas why this is happening?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trouble Reading Drivers Station Digital Inputs | Mike Mahar | C/C++ | 3 | 03-02-2009 23:37 |
| Drivers Station Magical Current | 3DWolf | Electrical | 5 | 25-01-2009 21:52 |
| Drivers' Station Camera Feed | dhawk085 | Technical Discussion | 4 | 25-01-2009 19:12 |
| Flashing Driver Station Digital Input | MacGyver1718 | FRC Control System | 3 | 15-01-2009 19:22 |
| Interrupt on driver station digital input | Nameless | Programming | 9 | 04-12-2008 16:55 |
Threaded Mode