|
|
|
 If you want to use the don't ask, don't tell logic about asking then you know it is wrong. - Steve W [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you want to use the don't ask, don't tell logic about asking then you know it is wrong. - Steve W [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
09-02-2009, 13:21
|
|||||
|
|||||
|
Re: connecting th encoder
|
|
#3
09-02-2009, 14:44
|
|||||
|
|||||
|
Re: connecting th encoder
Quote:
"Encoder" usually refers to a quadrature encoder used for sensing shaft rotation, which is usually connected to a pair of digital inputs. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Screwing Encoder into Encoder Mount? | Adrien | Electrical | 3 | 25-01-2009 18:14 |
| Connecting IR Board | Gizmo2417 | Electrical | 5 | 18-02-2008 01:58 |
| connecting sensors | guy_rom | Electrical | 4 | 01-02-2008 13:21 |
| Connecting Switch to RC | Mr. Steve | Control System | 2 | 28-01-2005 22:37 |
| Connecting 2 Keyangs to a Victor? | Jim Meyer | OCCRA | 3 | 14-10-2001 20:33 |
Linear Mode
