|
|
|
 Wait, I thought 2009 started on January 3rd... - ComradeNikolai [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Wait, I thought 2009 started on January 3rd... - ComradeNikolai [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Need some help with programming pneumatics.
I'm a rookie programmer with team 2521, I've never used LabVIEW before this season, nor been on a team until this season and am pretty much self taught. I know that I wired the solenoid and pneumatics breakout correctly.
-The pneumatics breakout is in module 8 on the cRIO. -The solenoid wire is plugged into the breakout, white to negative, red to signal. -The wire is plugged into the solenoid, white to negative (1), red to positive (2). My two problems are this. 1) The solenoids are always open at default, is there any way to change this? 2) When I use the third button on the joystick plugged into USB 1, nothing happens. Any help would be appreciated.  
|
|
#2
10-02-2009, 00:23
|
|||||
|
|||||
|
Re: Need some help with programming pneumatics.
Last edited by Mark McLeod : 10-02-2009 at 00:35.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I need some help with programming the Pneumatics | DPTeam270Driver | Pneumatics | 1 | 01-05-2008 18:58 |
| NEED HELP WITH uncontrollable pneumatics | Tds123 | Pneumatics | 6 | 11-02-2008 04:34 |
| NEED HELP WITH WHOLE PNEUMATICS | Reaper40 | Pneumatics | 2 | 17-02-2007 21:23 |
| Need Help With General Pneumatics | Ryan O | Programming | 7 | 24-01-2007 21:31 |
| hey need some help with writing a code please help me here | magical hands | Programming | 9 | 01-01-2004 21:46 |
Hybrid Mode
