|
|
|
 If your heart is racing and you feel a little nervous, then you're on the right side of the alliance station wall!;) - David Brinza [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| If your heart is racing and you feel a little nervous, then you're on the right side of the alliance station wall!;) - David Brinza [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#1
|
|||
|
|||
|
Debugger memory offset error
I can deploy code to the CRIO, but I can not debug code to it. When I try to debug, I get tossed an error message saying "WTX Loader Error:Relocation offset too large" It does that even with the default code. I just started today. The only thing I did differently was to modify my project's build properties to match those of all the defualt code properties. Does anyone know what this means?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera offset a lot.... odd | Tom Line | Programming | 6 | 08-02-2007 19:29 |
| spider foot offset | Drew | General Forum | 8 | 14-01-2007 02:24 |
| Servo Offset -> Angle conversion | bush | Programming | 11 | 30-01-2006 13:34 |
| extend offset | gondorf | General Forum | 2 | 28-01-2006 02:09 |
| c debugger | stephenthe1 | Programming | 16 | 09-12-2004 14:49 |
Threaded Mode