Help computer wont recognize cRio

bio hazard · #1 14-02-2009, 10:54

Help computer wont recognize cRio we plug the robot in to the computer threw a ethernet cord and do the labview connection check and 4 lights are green and the cRio is red help.

airnate · #2 14-02-2009, 11:23

Can you give us some more details? Where are the lights that you are seeing?

Is this the first time you've hooked up the cRIO? Was it working previously?

Have you already been through the bench tests suggested in the FRC Control System Manual (chapter 2)? If not, take a look, particularly at Chapter 2 Getting Started:

Control System Manual
http://www.usfirst.org/community/frc....aspx?id=10934

airnate · #3 14-02-2009, 16:57

Can you be more specific about which lights you are looking at? Which device are the lights on?

Have you previously hooked up the cRIO successfully? Or is this the first time?

bio hazard · #4 14-02-2009, 19:24

Quote:

Originally Posted by airnate

Can you be more specific about which lights you are looking at? Which device are the lights on?

Have you previously hooked up the cRIO successfully? Or is this the first time?

this is the first time that we hooked it up.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CRIO HELP!!!	lordsoze	Technical Discussion	8	07-02-2009 08:48
cRIO wont save program	Arcre	NI LabVIEW	5	07-01-2009 11:45
Premiere won't recognize camera - please help	sanddrag	IT / Communications	9	04-01-2007 20:17
Computer Help	Schnabel	Chit-Chat	7	09-12-2006 09:00
New Computer Help Show!	MattK	Chit-Chat	12	03-10-2002 21:15