|
|
|
 You should never, EVER bully, manipulate, or slander another team for the sake of winning. - Libby K [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You should never, EVER bully, manipulate, or slander another team for the sake of winning. - Libby K [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
CIM Legality
In the rules section <R51> it states:
"D. One or two additional 2-1/2” CIM motors (part #FR801-001 and/or M4-R0062-12) in addition to those provided in the Kit Of Parts. This means that up to four, and no more, 2-1/2” CIM motors can be used on the ROBOT." So, the question then is, Can a CIM motor of a larger or smaller size than mentioned in <R51 D> (2-1/2” CIM motors) be legally used on the robot (that are not of a previous robots)? By all suppositions and according to <R52 A> "(Motors that are prohibited)Electric motors and/or servos different from, or in addition to, those in the Kit of Parts, with the exception of those specificalLy PERMITTED in <R51>.". This implies that becuase motors that are not of the sizes of the CIM motors mentioned in <R51> are allowed they are therefore mentioned in that section and are thus legal. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| witricity legality? | XXShadowXX | Electrical | 68 | 10-05-2008 07:58 |
| NJ Regional: IR Legality | LH Machinist | Control System | 17 | 29-02-2008 06:27 |
| Legality question | SonicKidGJ | VEX | 6 | 13-01-2008 14:00 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| legality question | rbayer | General Forum | 8 | 15-09-2002 00:25 |
Threaded Mode