|
|
|
 Cash is always better, remember that when fund raising. - LordDumpling [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Cash is always better, remember that when fund raising. - LordDumpling [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Deploying not working
In labview, we're trying to deploy our code and it isn't working. When we hit deploy it goes until the bar hit's the end and then somewhere we lose a connection. We built the target in the way that was specified in the labview programming guide to the dot. Help?
|
|
#2
16-02-2009, 22:09
|
|||
|
|||
|
Re: Deploying not working
The next time, don't click the dialog to cancel, but let it go. LV realtime puts up the dialog when the communications takes more than around five seconds.
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera not working... | AG-chadd | Programming | 4 | 04-02-2009 22:10 |
| p2 not working? | Lone_Wolf92c | Programming | 5 | 22-02-2008 08:49 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| gyro not working | johnsmith11111 | Programming | 4 | 14-02-2008 17:13 |
| Radios not working... | E Jones 234 | Electrical | 3 | 21-01-2005 21:58 |
Linear Mode
