|
|
|
 Most of the people who fit the profile of long tenured FIRST mentor are either already on a team or locked up in an institution where they belong... - PayneTrain [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Most of the people who fit the profile of long tenured FIRST mentor are either already on a team or locked up in an institution where they belong... - PayneTrain [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Auto Code
We are having a problem with the auto code in LV...
Could somebody please just post a screen shot of there auto code just so we can see how you set it up?? We think its a watchdog failure but now sure. We also tried just loading the default CRIO project code and we enable the T F statement in auto independent Any ideas why are auto won't enable with default code?? Thanks TechTigers |
|
#2
19-02-2009, 00:53
|
|||||
|
|||||
|
Re: Auto Code
If I try to test the default Autonomous Independent VI by clicking the Run arrow on the Basic Robot Main VI, most of the time it works, but sometimes it won't enable. It never enables when I'm using the older slow programming laptop, so I figure it's an issue with the program running too slow to feed the watchdog properly when the front panel windows are open.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EasyC for FRC: Drive and Auto Track Camera Code | Kingofl337 | Programming | 7 | 08-01-2007 15:30 |
| auto | Tachion | FIRST Tech Challenge | 3 | 17-11-2005 11:25 |
| AUTO TRACKING!!!!!!:( | magical hands | Programming | 15 | 15-02-2005 19:27 |
| Auto Air Pump Code | zorro | Programming | 25 | 05-01-2003 16:50 |
| [white paper] Auto-Balance Gyro Code | Brandon Martus | Technical Discussion | 3 | 21-06-2001 10:36 |
Linear Mode
