|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Joystick value in autonmous
Its not really a LabVIEW question, but it still stands, can you inputs in from the driver station in autonomous?
|
|
#2
|
|||
|
|||
|
Re: Joystick value in autonmous
I am not absolutely sure, but it would be counter to the purpose of autonomous to allow input when the robot should be acting on its own, so I am almost certain you can't.
- Sam |
|
#3
|
|||
|
|||
|
Re: Joystick value in autonmous
From what I've heard, you can't, although you can read the value during the disabled period immediately preceding autonomous(so you can still set mode switches and such)
|
|
#4
|
||||
|
||||
|
Re: Joystick value in autonmous
Quote:
Actually the drivers aren't even allowed at the station during autonomous, so it wouldnt matter if u programmed it in |
|
#5
|
|||
|
|||
|
Re: Joystick value in autonmous
Are you wanting to read DS switches? If so, you can do this during auto-disabled. If using the advanced template, this is very easy. If basic, there are a few more steps. This has already been described before, but if you can't find it, ask specifically for what you are looking for.
Greg McKaskle |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GetAlliance value | nathanww | C/C++ | 2 | 15-02-2009 11:09 |
| Value of degree to calculate range? | Ianuser | Programming | 20 | 14-02-2007 15:34 |
| autonmous corner or center | dan da' geekman | Rules/Strategy | 55 | 09-01-2006 14:48 |
| Need autonmous? | the_undefined | Programming | 0 | 21-04-2005 22:28 |
| Value of Defense | archiver | 1999 | 4 | 23-06-2002 22:21 |