Programming a boolean switch.

02-03-2009, 19:52

Dr. Manhattan Dr. Manhattan is offline

Atomic Reconstruction

AKA: Joe Bakke

FRC #2521

Team Role: Programmer

Join Date: Jan 2009

Rookie Year: 2009

Location: Eugene, OR

Posts: 21

Dr. Manhattan is on a distinguished road

Programming a boolean switch.

We have a basic (Physical) boolean switch that's wired to DIO 2. I'm not completely sure how to wire this in labview, but what I have now is.

1) DIO in (Open)
2) DIO in (Get)
3) The get connector is wired to a case statement

Is this correct? Or is there another way to program it?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wiring a boolean switch.	Dr. Manhattan	Electrical	2	08-03-2009 11:26
programming a switch	Mr. E	Programming	18	26-02-2007 19:10
Momentary Switch Programming	silv940	Programming	3	24-05-2006 02:19
Problems programming a switch	caderader	Programming	2	18-02-2005 22:06
3 way toggle switch programming	LeadRiccardoT	Programming	3	17-02-2003 02:02

All times are GMT -5. The time now is 10:34.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.