[FTC]: Using two Hitechnic Motor Controllers in LabView

Maybe FIRST will just take 148's Tumbleweed and use it as the game piece for next year. - AndyB [more]

		Chief Delphi > Other > FIRST Tech Challenge
[FTC]: Using two Hitechnic Motor Controllers in LabView

Thread Tools

Rating:

Display Modes

05-03-2009, 20:09

ZSLAYTER

Registered User

FTC #2882

Join Date: Mar 2009

Location: Coppell

Posts: 1

ZSLAYTER is an unknown quantity at this point

[FTC]: Using two Hitechnic Motor Controllers in LabView

Hey, does anybody know how to program in two Hitechnic Motor controllers in Labview, because we have three motors, and in labview, it only gives the choice between Motor A, or Motor B! How do I get a third motor programmed??

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FTC]: OUT OF MOTOR CONTROLLERS?!?!?!?	ttldomination	FIRST Tech Challenge	6	09-02-2009 18:48
[FTC]: Labview can't use two controllers	dman14	FIRST Tech Challenge	8	04-02-2009 21:09
[FTC]: Tips page on using FTC Encoders with LabVIEW	PhilBot	FIRST Tech Challenge	7	27-01-2009 14:00
[FTC]: Problem with two controller setup in Labview	wilsonmw04	FIRST Tech Challenge	2	11-11-2008 19:58
[FTC]: FTC Servo-Motor Problem with Labview	dnhansen	FIRST Tech Challenge	1	26-10-2008 00:43

All times are GMT -5. The time now is 10:41.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.