|
|
|
 "Mentors Only Work When Being Calibrated". - Calvin Hartley [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "Mentors Only Work When Being Calibrated". - Calvin Hartley [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Sprocket Ratios
Our team is currently involved in some last minute programming and we were having trouble figuring out what sprocket ratios to do our calculations with because obviously we shipped the necessary sprockets over a month ago with our robot. Here's our three questions:
1) Is the encoder axle the same as the drive axle (in terms of the gearbox for the 2009 KOP)? 2) How many teeth are on the drive sprocket (2009 KOP)? 3) How many teeth are on the driven sprocket (2009 KOP)? Any help on this would be great! If any clarification is needed on any part of these questions I'd be happy to do so. Thanks! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| suggested gear ratios | Bruceb | General Forum | 3 | 07-01-2009 14:15 |
| Gear Ratios | Joe_Widen | Technical Discussion | 17 | 13-05-2006 15:06 |
| gear ratios | roboteer49 | Motors | 22 | 29-04-2004 20:51 |
| Gear Ratios | Joshua May | Kit & Additional Hardware | 4 | 01-02-2004 22:54 |
| Gearing Ratios | satyam | Motors | 1 | 31-01-2004 09:50 |
Threaded Mode