[FTC]: Our motors are too slow :(

Part of Gracious Professionalism is the Professional bit. Doesn't matter if you're a volunteer or a staff member, a failure of this level in the real world would result in getting fired. - [more]

		Chief Delphi > Other > FIRST Tech Challenge
[FTC]: Our motors are too slow :(

Thread Tools

Rate Thread

Display Modes

27-11-2009, 13:46

aybose

Registered User

FTC #2485

Join Date: Feb 2009

Location: San Diego

Posts: 8

aybose is an unknown quantity at this point

[FTC]: Our motors are too slow :(

We are programming in Labview, and have just a simple block to maximize our power to 127 on our motors. We have a 1:26 gear ration, and the motors are still waay to slow. Is there some other block that should be in the program to get to the max speed?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FTC]: Slow Down Max Speed!!	JohnFogarty	FIRST Tech Challenge	10	16-11-2009 13:24
Analog to Digital Conversion too Slow	Dave McLaughlin	Programming	2	09-02-2008 23:21
Camera servos too slow, help please	Lablabla	Programming	9	19-01-2007 11:59
Kitbot/cims/transmissions running too slow?	Swampdude	Technical Discussion	28	23-01-2005 11:17
How slow is too slow?	Joe Ross	Rules/Strategy	23	12-10-2004 20:23

All times are GMT -5. The time now is 18:32.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.