cRIO imaging

alex42 · #1 15-01-2010, 19:26

The cRIO imaging tool can't find the cRIO. The driver account on the DS can tell whether or not the cRIO is there, but when I try to run the cRIO imaging tool on the developer account, it never finds the cRIO.

bladetech932 · #2 16-01-2010, 00:24

Are you using the crossover cable to connect from the classmate to the C-RIO?

alex42 · #3 16-01-2010, 14:55

Yes. Initially we weren't, but then we realized our mistake. There was no apparent effect from switching to the correct cable though.

alex42 · #4 16-01-2010, 20:05

Turns out the problem was that the cRIO was in safe mode. We didn't realize it because the switch looked like it was off. Also that the wifi connection was turned on.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cRIO imaging tool	dnrobotics11	Programming	4	14-01-2010 23:32
Imaging Tool does not find cRIO	aeasson	FRC Control System	2	10-01-2010 20:39
Problem with cRIO Imaging Tool	Doc Wu	FRC Control System	7	15-12-2009 19:47
cRIO Imaging Tool HELP PLEASE!!!	furiousgeorge	FRC Control System	2	08-02-2009 22:44
FRC cRIO Imaging Tool	furiousgeorge	Programming	1	06-02-2009 09:52