|
|
|
 This brings back childhood memories of playing with erector sets... Wait. I still do. :D - Whippet [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| This brings back childhood memories of playing with erector sets... Wait. I still do. :D - Whippet [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Gearbox Output Shaft Defect
Hi, I am from team 2974; we are a second year team.
In assembling our gearboxes, we stumbled across an issue pertaining to the gear shafts. One of the shafts had an input 1mm too wide in diameter but had a proper output size. On the other hand, the other shaft had the proper input diameter but the output diameter was off by approximately .05 mm. If anyone else encounters this error, let us know. We would like the community to be aware that faulty parts are afoot! -Nathan 
|
|
#2
16-01-2010, 10:21
|
||||
|
||||
|
Re: Gearbox Output Shaft Defect
|
|
#3
16-01-2010, 10:26
|
|||||
|
|||||
|
Re: Gearbox Output Shaft Defect
Thanks for the reminder that teams who plan to use the kit transmission should at least test assemble it soon, so any problems can be fixed right away. AndyMark is very good about sending replacement parts right away, but you have to let them know you have a problem.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| roll pin into output shaft | m1k3 | Kit & Additional Hardware | 18 | 15-01-2008 16:18 |
| diameter of transmission output shaft | sj31419 | Electrical | 5 | 17-02-2005 22:09 |
| Cutting the output shaft | Kevin A | Technical Discussion | 2 | 18-02-2003 01:47 |
| Securing hex shaft to drill output | D. Gregory | Technical Discussion | 6 | 24-01-2003 14:05 |
Linear Mode
