|
|
|
 If something on your robot isn't working, then why don't you take the responsibility to fix it? Isn't that what being a TEAM is all about? - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If something on your robot isn't working, then why don't you take the responsibility to fix it? Isn't that what being a TEAM is all about? - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Inventor - Contact Sets with Compression Springs
I am using Inventor to model a trigger mechanism. The mechanism include a compression spring, but when I add the spring to a "contact set" the spring does not compress. Does anyone know a method of getting springs to compress when using "contact sets"?
I have included a wire frame screen grab of my Inventor model. You can see the spring located to the right of the drawing. The block on the left should slide over the blue lever and catch, but the spring isn't compressing to allow this action. Thanks! -Team 1711 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| help with the inventor[robot part missing] (ajuda no inventor[parte do robo faltando] | team 2244 | Inventor | 6 | 12-02-2007 06:16 |
| Springs in Inventor | dylanandsarah | Inventor | 10 | 05-02-2007 19:42 |
| Contact with the Rack | robotguru1717 | Rules/Strategy | 35 | 08-01-2007 13:48 |
| Spring Compression in Inventor 6? | psychoCHIPMUNKK | Inventor | 1 | 23-05-2004 13:44 |
| Looking for contact with Millenium team. | Gene F | General Forum | 3 | 09-11-2003 13:18 |
Hybrid Mode
