|
|
|
 Students dream up the ideas for bots, it is than up to the mentors and engineers to make these dreams a reality. - dddriveman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Students dream up the ideas for bots, it is than up to the mentors and engineers to make these dreams a reality. - dddriveman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Cypress board LAYOUT
Hi, i have spent an hour looking through posts on chief delphi and have been unable to find detailed instructions on using the cypress board. we configured it and can connect to it fine, but we cant figure out how to use it. I took a switch that was wired from last year (with a pwm cable and a resistor on the red wire), and connected the black to ground, red to the top, and the white to P4_5. what do we do from there? we would like for this switch to control Digital Input 1. THANKS for any help
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cypress Board Issues | kgzak | FRC Control System | 4 | 02-02-2010 18:40 |
| Cypress Layout (over wires?) | flameout | FRC Control System | 18 | 23-01-2010 18:09 |
| Cypress board | bls0620 | Electrical | 4 | 17-01-2010 23:22 |
| Cypress Board Configuration | Geek 2.0 | FRC Control System | 12 | 17-01-2010 04:23 |
| Cypress IO board connect | SteveD | FRC Control System | 12 | 16-01-2010 16:46 |
Threaded Mode