|
|
|
 A world where lawyers and police don't get much work -- there's a goal to work toward. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A world where lawyers and police don't get much work -- there's a goal to work toward. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Programming the Psoc
We followed the steps to program the psoc.. We got to where it asks us to find the FRC_IO.v2.hex file and we found it and clicked on it.. It should have a FirstTouch listed under the Port Selection but it's not there..
Why would this not be there? Do we have to have our psoc connected to the breadboard.. if so, where? Also, what is the purpose of the psoc? Do we have to have the psoc? Or is it just an add-on? Thanks so much for your help, please post!! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PSOC Interface Card | Lafleur | Technical Discussion | 4 | 09-02-2010 13:26 |
| Programming the PSoC | PortugazD.Ace | Programming | 19 | 31-01-2010 13:14 |
| Programming the IR | Pi Boy | Sensors | 3 | 21-01-2008 15:47 |
| Programming the vex microcontroller to respond to commands on the serial port | crashoverride02 | Programming | 1 | 20-10-2006 14:17 |
| Programming The CMUcam for the Vex controller | 987HighRoller | Programming | 3 | 24-06-2006 15:27 |
Threaded Mode