|
|
|
 I don't want a carbon copy of your wheels.. I want to improve upon your design. - Tom Bottiglieri [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't want a carbon copy of your wheels.. I want to improve upon your design. - Tom Bottiglieri [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Programming Mecanums in Labview
This is our first year using Mecanum drive and we are having some trouble with programming these wheels in Labview. I realize there are a couple of threads discussing this topic, but I have some specifics I would like addressed. For instance:
1. Do you need one joystick or two to control the drive? 2. Can the holonomic vi be used for this drive system? 3. Are there any tutorials available that address this topic? 4. Any suggestions or tips? Any information you could supply me with would be very helpful and appreciated. Thanks! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview servo programming | Delvadar | NI LabVIEW | 9 | 01-02-2010 20:29 |
| Programming Toggle Switches in Labview | seanl | Programming | 1 | 16-02-2009 13:02 |
| FRC LabVIEW programming | dlesley | National Instruments LabVIEW and Data Acquisition | 2 | 15-12-2008 13:21 |
| Basic Labview Programming Questions | comphappy | NI LabVIEW | 20 | 13-10-2008 18:29 |
| Labview Programming question | pollyproof12 | General Forum | 2 | 30-09-2008 16:29 |
Threaded Mode