8020 Mass - Chief Delphi

I don't really care that the best on Curie may or may not be better than Newton, since we're going to spend the rest of the offseason discussing it no matter how the decision fell. - Jessica Boucher [more]

		Chief Delphi > Technical > CAD > Inventor
8020 Mass

Thread Tools

Rate Thread

Display Modes

19-01-2010, 18:18

Tanner

Registered User

FRC #1261 (Roblions)

Team Role: Programmer

Join Date: Jan 2007

Rookie Year: 2007

Location: Suwanee, GA

Posts: 311

8020 Mass

Hi,

Does anyone know how I would put the mass of 8020 into a part?

I found the iProperties' Physical settings, but I don't know the density of it to put in. I'm not even sure if that is the right place to go.

Ideas?

-Tanner

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: What goes on those 8020 Rails??	Thermal	Extra Discussion	7	10-01-2009 08:12
pic: 8020 Chain Tensioning idea	Andy L	Extra Discussion	12	03-11-2008 16:08
Center of Mass question	Alex1072	Technical Discussion	11	26-01-2005 17:03
Mass properties in Inventor	telkanuru	Inventor	2	26-02-2004 21:59
Need help in Mass.?	CaptainPlaid	General Forum	1	16-12-2002 12:15

All times are GMT -5. The time now is 01:54.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.