|
|
|
 Even with everyone using the same RC setup, teams still botch it in many creative ways. - Wetzel [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Even with everyone using the same RC setup, teams still botch it in many creative ways. - Wetzel [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
cRio problem
We have connected and updated the cRio imaging already, however now we are unable to connect anything to the cRio. Does anyone have any advice on what is going on?
|
|
#2
20-01-2010, 16:05
|
|||
|
|||
|
Re: cRio problem
attempt to tether the cRio to your drivers station using Ethernet port 1 on the cRio...
also, make sure the cartridges on the cRio are in the right position... However, your descrition was slightly bland. Could you be more specific? |
|
#3
20-01-2010, 16:10
|
|||
|
|||
|
Re: cRio problem
We have tried tethering to the drivers station (old and the new netbook) and it was unsuccessful. We were able to ping the robot from the netbook and got a response, but when we try to tether the netbook to the cRio a connection can not be made.
|
|
#4
20-01-2010, 16:18
|
|||
|
|||
|
Re: cRio problem
Also we have the new cRio image on the cRio, but when we came in today to get back to work we were unable to connect to the cRio. What else would you like to know so you can help us?
|
|
#5
21-01-2010, 16:19
|
|||
|
|||
|
Re: cRio problem
Quote:
Are you logged into the driver account? Do you have multiple network interfaces enabled on the classmate? Do you have the IP address on the classmate / cRIO set correctly? |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO communications problem | alex42 | FRC Control System | 5 | 16-01-2010 20:22 |
| Problem Configuring cRIO | shoffing | FRC Control System | 5 | 17-02-2009 08:29 |
| cRio corruption/polling problem | nathanww | Technical Discussion | 1 | 04-02-2009 23:24 |
| cRIO Problem | Pneumaticsman | NI LabVIEW | 8 | 10-01-2009 11:59 |
| cRIO plugin problem | gabrielse | National Instruments LabVIEW and Data Acquisition | 3 | 18-12-2008 11:30 |
Hybrid Mode
