|
|
|
 Being rude is easy. Being a compassionate human being takes work. - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Being rude is easy. Being a compassionate human being takes work. - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
password for software update?
I downloaded the software update: FRCLabVIEWUpdate2.0for2010.zip
and DSUpdate1.0for2010.zip. - Do I need to install both of them? I don't have the password to unfold them. I got the password announced at kickoff from a teammate who went to the kickoff, but somehow it doesn't work. Any ideas? 
|
|
#2
21-01-2010, 16:10
|
|||||
|
|||||
|
Re: password for software update?
The password for the DS update was Breakaway4FRC! , and I believe it's the same for the labview update. I had to unzip them with WinRAR...
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Update password | furiousgeorge | Control System | 12 | 18-01-2010 21:48 |
| Password Protected Update | jrws | NI LabVIEW | 2 | 15-01-2010 03:16 |
| Where do I get a password for inventor? | VEI Dude | CAD | 2 | 25-01-2009 13:37 |
| Password for 2.5 Stamp | MechaJagEric | General Forum | 2 | 18-01-2003 13:46 |
Linear Mode
