CRIO Shock rating - Chief Delphi

A Guru teaching batteries at Exide: "Do not draw your power from up here, by your terminals. You must reach down deep into your plates and pull the energy from your entire being! You must prove yourself worthy to be FIRST power cells!" - KenWittlief [more]

		Chief Delphi > Technical > Control System > FRC Control System
CRIO Shock rating

Thread Tools

Rate Thread

Display Modes

21-01-2010, 23:16

n_ambrogi013 n_ambrogi013 is offline

Registered User

FRC #0131

Join Date: Jan 2009

Location: Manchester, NH

Posts: 7

n_ambrogi013 is an unknown quantity at this point

CRIO Shock rating

After watching our kitbot frame traverse the bumps a few times, some team members asked if we would want to use some sort of shock mitigation system to protect our control system.

I checked on National Instruments' website, i saw that one model of the CRIO is rated to 50 g. Does that seem reasonable? We'd love to save weight by not using any kind of shock absorbers, but we'd also hate to break the control system. Any thoughts?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
On board shock datalogger?	ChuckDickerson	General Forum	21	07-01-2008 08:10
Shock absorbers?	ZoNeGuY	Rules/Strategy	1	16-02-2005 11:19
FIRSTStar(TM) Rating	Joe Johnson	General Forum	36	03-05-2002 11:39
Rating Threads	Tom Fairchild	CD Forum Support	1	27-11-2001 12:42

All times are GMT -5. The time now is 05:53.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.