|
|
|
 -Best FIRST Robot: One that Makes it to Competition - Conor Ryan [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| -Best FIRST Robot: One that Makes it to Competition - Conor Ryan [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Robot code isn't loading onto driver station
Hello. We are having trouble getting our robot to work. We have successfully built and deployed a basic project (changing from arcade to 4-motor tank drive), yet our driver station can't read any code on the robot. It was working fine until we attempted to install an update. We believe that we improperly installed it before, but now we have fixed it. Please help.
Last edited by TigerDrive2391 : 23-01-2010 at 17:18. Reason: Not specific enough |
|
#2
23-01-2010, 21:40
|
|||||
|
|||||
|
Re: Robot code isn't loading onto driver station
You think you're deploying code successfully, but the Driver Station disagrees? One thing that can cause that symptom is not having the proper image in the cRIO. Have you re-imaged it with the v19 file?
|
|
#3
24-01-2010, 15:32
|
|||
|
|||
|
Re: Robot code isn't loading onto driver station
Thanks for your help we figured it out by ourselves and it was the C-rio not being reimaged properly.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Deploying code from the 2010 driver station - Netbeans | joshholat | Control System | 5 | 23-01-2010 15:01 |
| Driver station not detecting robot code | captainking | NI LabVIEW | 9 | 21-01-2010 10:39 |
| Save code to Driver Station | Comatose | Programming | 5 | 17-01-2009 18:48 |
| Loading Code Onto 2005 RC | chris31 | Programming | 13 | 08-11-2006 07:45 |
Linear Mode
