Code downloaded but not working... :(

pudgeball · #1 01-27-2010, 02:07 PM

Alright so our team, team 2386 got all the updates for the software and driver station. Today I updated the cRio to v19 and we finally got the programming laptop able to download code. Then when we went to test the code nothing happened. There was a green light for Robot Code, but I was unable to use the robot. Anyone have any ideas?

Alan Anderson · #2 01-27-2010, 02:10 PM

Did you click the "Enable" button on the Driver Station to enable the robot?

pudgeball · #3 01-27-2010, 02:17 PM

Haha yea I tried all the modes and enabled them all. No luck on all fronts.

Alan Anderson · #4 01-27-2010, 09:20 PM

Quote:

Originally Posted by pudgeball

Haha yea I tried all the modes and enabled them all. No luck on all fronts.

I don't understand what you mean by "all the modes". There's a red and green button on the operations tab to enable or disable the robot. That's the one I'm talking about.

Can you describe what the Robot Status Light is doing when you try to run your program?

pudgeball · #5 01-28-2010, 11:04 AM

Sorry about this thread, I found the error while re-reading the documentation. The electrical was screwed up. We got the robot working.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
C++ Sample Code not working...	hm29168	CAN	5	01-27-2010 08:59 PM
Downloaded program, but no response	program1	Programming	4	01-10-2009 06:42 PM
IR Board Not Working (But NOT Fried)	itsme	Electrical	2	02-18-2008 06:11 AM
Incrementation Code not working	benhulett	Programming	6	02-12-2007 05:39 PM
frc_camera not working but labview does	Issues	Programming	7	01-18-2006 07:23 PM