|
|
|
 This is a game folks, and rules are rules, even if you kinda sorta broke one rule in the end its still broken
- Mike Schroeder [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| This is a game folks, and rules are rules, even if you kinda sorta broke one rule in the end its still broken
- Mike Schroeder [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
help with the I/O
hEy
i HAVE APROBLEM HOPE U CAN HELP ME!!!  we have installed the I/O ,it was okay at the beginning but now after we download a code it seems not connected (the green light at the classmate is not flashing gren) ,do this unit need programming??? because at the messages tap at the classmate shows " Make sure the unit has been programmed" HELP ME  
|
|
#2
31-01-2010, 02:17
|
|||
|
|||
|
Re: help with the I/O
There is a hex file in the Shared Documents folder that needs to be programmed onto the PSoC board.
However unless you plan on wiring up a custom control panel you don't need to worry about the Cypress I/O module. Most teams only use Joysticks and don't need the I/O and can therefore safely ignore that message.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can any one help us with programing the encoder to control the motor by ticks? | Must Be Drama | NI LabVIEW | 4 | 09-02-2009 20:54 |
| HELP!!! STUCK WITH SUB ROUTINES WITH THE IR!!! | drewjones13 | Programming | 1 | 17-01-2008 20:52 |
| need help with the ir | tinderfitles | Programming | 3 | 03-02-2004 15:31 |
| Help with the storyboard. | LizJJury | 3D Animation and Competition | 11 | 13-01-2003 08:37 |
| Please help me with the size of the rotating light!!! | bigqueue | Technical Discussion | 5 | 21-01-2002 09:40 |
Linear Mode
