|
|
|
 We call ourselves community/family. We are. Our kitchen table where we gather is the size of Chief Delphi. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| We call ourselves community/family. We are. Our kitchen table where we gather is the size of Chief Delphi. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#1
|
||||
|
||||
|
Problem using encoders on Jaguar
We have a quadrature encoder wired to the encoder inputs on the Jaguar, yet niether the TI utility, bdc-comm nor labview can use the jaguars in speed mode. In the bdc-comm utility, the option to use encoders is grayed out (see picture attached). Controling the jaguar and motor via Voltage mode works perfectly, but controling it via speed or position mode does not. does anyone have any ideas on how to fix this problem?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Encoders | svenw | C/C++ | 2 | 14-01-2010 16:43 |
| Benchmark Test Jaguar Problem | xxsumz | Motors | 3 | 13-02-2009 21:48 |
| Jaguar Problem | Sauce | Electrical | 7 | 10-01-2009 14:28 |
| Jaguar Motor Controller Problem | prashil27 | Electrical | 5 | 07-01-2009 21:21 |
| Autonomous using encoders | Mr.G | Programming | 11 | 17-01-2006 03:34 |
Threaded Mode