|
|
|
 I can't help but notice during the building sequence, there were a whole lot of student hands working on that robot.
Just sayin'. - Taylor [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I can't help but notice during the building sequence, there were a whole lot of student hands working on that robot.
Just sayin'. - Taylor [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Kit opto encoder resolution?
What is the resolution (in pulses per turn) of the KOP's optical encoders? I need to find out the scaling value to plug into the open VI for the encoders in LabView.
The datasheet says "400-1440" ticks per rotation. This is obviously not helpful. Also, I assume you don't have to specify the quadrature decoding type, right (1x, 2x, or 4x?) I would assume it gets that right without modification. Thank you for any help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Screwing Encoder into Encoder Mount? | Adrien | Electrical | 3 | 25-01-2009 18:14 |
| VEX Shaft Encoder Kit | jeffmorris | FIRST Tech Challenge | 1 | 19-05-2006 12:23 |
| DPI resolution | Branden Ghena | IT / Communications | 6 | 17-04-2006 14:43 |
| Resolution of IR sensors | Paul Marshall | Technical Discussion | 2 | 16-01-2004 14:03 |
| Resolution... | Brandon Martus | CD Forum Support | 9 | 15-05-2002 18:49 |
Threaded Mode