|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Passing the main robot frame with the kicker.
--------------------------------------------------------------------------------
Can our kicker leg pass the main frame of the robot while it is kicking??? Because it would be very hard to kick the ball in 3 inches. As we know we can let the kicker out for 2 seconds to kick. |
|
#2
|
||||
|
||||
|
Re: Passing the main robot frame with the kicker.
It sounds like you answered your own question in the last sentence. What exactly are you asking?
The kicker can extend outside the frame (but not the bumpers) for 2 seconds, then it must be brought back into the frame. Last edited by sgreco : 12-02-2010 at 07:21. |
|
#3
|
||||
|
||||
|
Re: Passing the main robot frame with the kicker.
Yes, you can extend up to the bumper perimeter, but can not exceed the bumper perimeter. The 2 seconds is the amount of time the kicker can be between the robot frame perimeter and bumper perimeter. So you can contact the ball in about a six inch area, 3 inches inside the robot, and 3 inches in the horizontal bumper zone. Hope this helps.
|
|
#4
|
|||
|
|||
|
Re: Passing the main robot frame with the kicker.
See rule <G30a>
Your kicker can extend to the outer edge of the bumper for the sole purpose of interacting with the ball, for 2 seconds. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Passing the main robot frame with the kicker. | cilginbilgin | General Forum | 5 | 13-02-2010 06:35 |
| Connecting The Toughbox to the Robot Frame Video? | baihooli3022 | General Forum | 1 | 16-01-2010 14:25 |
| problem with passing doubles back into the "TeleOp Execute" loop | windell747 | NI LabVIEW | 1 | 21-03-2009 00:50 |
| Coordinating Robot Main VI with Autonomous VI | jjauss | Programming | 2 | 07-02-2009 09:26 |
| Passing Ringers to Robot over the Wall | nautica | Rules/Strategy | 15 | 01-03-2007 14:52 |