|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
How to connect the 12v solenoid to the cRIO and spike relay?
I am trying to set up the pneumatics but I don't know how or where to connect the solenoid. Do I need to connect it to the digital or analog on the cRIO. Do I need to use the spike relay and if so how do I do it. I would like pictures because it's hard to picture without it.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| multiple cRIO relay (solenoid) modules? | Alan Anderson | FRC Control System | 15 | 06-02-2010 17:41 |
| How to connect the Workbench with the cRIO? | kentschool | C/C++ | 3 | 28-12-2009 16:03 |
| How do you run the pneumatics through the CRio w/o using the Jaguars and the Spikes | brreadd | Pneumatics | 3 | 20-11-2009 15:35 |
| Pneumatics (Spike Relay, Solenoid etc.) Programming | oceansidehs | Programming | 8 | 10-02-2007 13:58 |