Error deploying after building program in labview

LavaEagle · #1 13-02-2010, 15:23

Hi. We are currently experiencing a problem where when we go to deploy the code after building it we get an error that says "Real time project has not been built yet". This isn't making sense as we have built the project before we ran as start-up. Our Classmate has been updated and that bis what we are using to deploy this code. Any help that we can get would be appreciated. Thanks!

Team 2660

Joe Ross · #2 13-02-2010, 23:37

Were there any errors in the build process?

LavaEagle · #3 15-02-2010, 12:34

It says that it can't save duplicate filenames in the same place, so it moved them to a unique location

Doug Norman · #4 15-02-2010, 16:43

Quote:

can't save duplicate filenames in the same place

This is typically a warning, not an error.

For errors you should scroll through the build dialog message. Also, at the end it will tell you if the build is complete, or if it had errors.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
error installing labview error 1335	jerometab	NI LabVIEW	0	06-02-2010 18:17
LabVIEW code deploying instead of running	linkhyrule5	NI LabVIEW	6	10-01-2010 14:57
Proper procedure for deploying Labview code?	domoarigato	NI LabVIEW	8	03-02-2009 06:52
Having trouble deploying after update 3.0A	Pwolter	Programming	1	30-01-2009 21:54
Program error after controller reset	randomperson	Programming	6	04-01-2005 23:31