|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Vision target mounting
After extensive puzzling and asking around, I am at a loss about the vision targets. Which side of the plexiglass will they be on? The manual says it is on the plexiglass, but that is pretty ambiguous. Does anyone know?
|
|
#2
|
|||||
|
|||||
|
Re: Vision target mounting
One would speculate that it'll be mounted to the back of the plastic, to protect it, but I'm not exactly sure how this might affect our robot's ability to "see" it, if at all.
|
|
#3
|
||||
|
||||
|
Re: Vision target mounting
I'm unclear on what the answer is, although my guess is the same as Don's, but I am curious to what you think the differences this will cause are.
|
|
#4
|
||||
|
||||
|
Re: Vision target mounting
having the plexiglass in front would cause a lot of glare.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vision Target!!! | Pancake | Programming | 4 | 22-01-2010 14:30 |
| Durability of Vision Target | geeknerd99 | General Forum | 13 | 11-02-2006 14:15 |
| Vision Target Assembly | platt | Kit & Additional Hardware | 4 | 26-01-2006 17:34 |
| vision target | Dakota Snow | Kit & Additional Hardware | 1 | 08-01-2006 23:00 |