|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
How can I extend my wireless reciever's power chord
I need to extend the power chord on the wireless receiver. Can I solder longer more wire on, or just connect the wire with electrical tape. Or do I have to buy wago connectors?
|
|
#2
|
|||
|
|||
|
Re: How can I extend my wireless reciever's power chord
solder and tape well. heat shrink tubing over the solder connections if you can. obviously make sure there is no contact between them. another consideration is crimp on connectors. (butt connectors most likely). there is nothing saying you must use wago brand connectors. just make sure the end connected to the PDB is connected using the supplied wago connectors.
|
|
#3
|
|||||
|
|||||
|
Re: How can I extend my wireless reciever's power chord
hannigan,
The proper method would be to obtain the correct connector from Radio Shack, Digikey or your local supply house and make a cable of the correct length. Other attempts are jury rig fixes at best. All of your robot commands run through the wireless adapter, if it dies so does your match. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can wheels extend past the frame? | toastnbacon | Rules/Strategy | 17 | 13-02-2010 15:48 |
| Can the robot extend outside of the bumper zone. | markulrich | Rules/Strategy | 15 | 08-01-2009 08:21 |
| New Control System Wireless Bridge Power? | Greg Marra | General Forum | 3 | 21-09-2008 17:19 |
| To extend or not to extend the ship date! | FIXIT | General Forum | 61 | 17-02-2007 14:47 |
| We can extend beyond the playing field with our ball-knocker-offer??? | Natchez | Rules/Strategy | 35 | 19-03-2004 09:35 |