Labview Project Template Files Not Opening

Yppiz · #1 19-02-2010, 20:20

I have Labview 8.6 and installed the latest update. However, since my original installation (mid-January), I have not been able to open Labview project template files. I am still able to write and save programs, but all FRC specific VI's seem to be missing certain dll files and thus not opening properly. I would appreciate some help on this issue.

Thanks!

Mark McLeod · #2 19-02-2010, 20:37

Did you install LabVIEW 8.6 from the DVDs that came in the Kit of Parts or some other way?

Yppiz · #3 19-02-2010, 20:55

I installed from the DVDs sent from FRC. I also uninstalled and reinstalled several times, but there is no change.

Mark McLeod · #4 19-02-2010, 21:42

Was LabVIEW already on the machine you're using, like an earlier version of LabVIEW?

Do you know what the original installation listed as a version under Help -> About FIRST Robotics Competition Software...

I'd try searching the NI FIRST Forums to see if they talk about similar installation issues there.

This is not the Classmate you're talking about I assume.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error opening project	elbuo	Programming	1	28-02-2009 21:31
Opening kevin's code as a project	windell747	Programming	0	16-02-2008 18:14
Project Engineering Job opening	Don Wright	Career	0	23-08-2006 15:41
Template Project	Astronouth7303	Programming	10	30-05-2004 20:05
Project Template File	Jon Abad	General Forum	1	12-01-2002 18:04