|
|
|
 If FIRST makes a field invisible to the audience, I will buy every team a dozen Krispy Kremes. - Chris is me [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| If FIRST makes a field invisible to the audience, I will buy every team a dozen Krispy Kremes. - Chris is me [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Norgren regulator question
Up until now, our air has been just fine. Now our regulator started leaking, and now I think it was just another bad connection. But now that I realize it, our regulator is rated at 50PSIG Max output (part no. R07-100-RNEA), up until today we had working fine at 60 PSI.
Any facts out there? |
|
#2
21-02-2010, 17:25
|
||||
|
||||
|
Re: Norgren regulator question
On the BACK of the valve there should be a set screw in place that you should start at first. Put teflon tape on the set screw and re-tighten it and make sure there aren't any leaks in the system again. Also, don't forget to make sure the arrow at the bottom of the regulator is pointing in the direction of the solenoids.. It needs to flow TO the solenoids, not away from. We had that issue and it wouldn't let our tanks fill up further than 60PSI
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does the Norgren Pressure Regulator show working pressure or stored pressure? | Madison | Pneumatics | 7 | 14-02-2008 17:40 |
| Voltage Regulator | Robby | Electrical | 5 | 18-01-2005 07:50 |
| 12v regulator | coreyjon | Electrical | 1 | 09-06-2004 22:08 |
| pressure regulator | blindguyinanorg | Pneumatics | 12 | 20-02-2004 08:54 |
| Need the number for the Norgren Pressure relief valve | Jack21 | Pneumatics | 0 | 23-01-2004 16:32 |
Linear Mode
