|
|
|
 We're 3 pounds over. Drill until the hole saw is too hot to touch, then go find something else to cut off while you wait for it to cool down. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| We're 3 pounds over. Drill until the hole saw is too hot to touch, then go find something else to cut off while you wait for it to cool down. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
HiTechnic Magnetic Compass Invalid Compass Manufacturer
Has anyone else gotten the NXT HiTechnic Magnetic Compass to work? I plugged it in to the side car in the I2C jack, but when I tried to create the HiTechnicCompass object the console would not complete the deploy process because of the following error, "Invalid Compass Manufacturer."
It would be nice to know whether the HiTechnicCompass class really works or not. I haven't tried the compass with the NXT recently, so I will try that again just to see whether it's fried or not. Also, we did get the FRC gyro to work and we will probably just go with that. In the mean time, if anyone has experience with the compass, please let me know. 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compass sensor | AlexGrant | Electrical | 16 | 01-14-2010 11:52 AM |
| HiTechnic compass - reading 65535? | oddjob | C/C++ | 3 | 02-08-2009 10:44 PM |
| Gyro Compass | Nathan | Programming | 5 | 01-16-2008 02:55 PM |
| Programming a Devantech Magnetic Compass - CMPS03 | kE7JLM | Programming | 7 | 09-28-2007 08:23 AM |
| Political Compass | Joshua May | Chit-Chat | 11 | 10-01-2004 10:32 PM |
Linear Mode
