|
|
|
 It's that science and technology inspiration stuff - never know where it'll take you. :) - JaneYoung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| It's that science and technology inspiration stuff - never know where it'll take you. :) - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: 1671 Electronics Board (90%)
|
|
#3
17-03-2010, 17:01
|
|||||
|
|||||
|
Re: pic: 1671 Electronics Board (90%)
We used ribbon last year with no problems. Kent, I can't tell from the picture but I see wires leaving the jaguars and going between two c channels on either side of the robot. If they (the channels) are at the same level, a good hit to the side of the robot might pinch the wiring. I like the layout, everything centered in the robot and short wiring that an inspector can easily see.
|
|
#4
17-03-2010, 17:19
|
||||
|
||||
|
Re: pic: 1671 Electronics Board (90%)
Rick as to your post above, we've noticed zero difference between ribbon and cable.
Al, to your point we already corrected that wire routing to go down through the board vs. around the outside edge just for that reason. This was a temporary mounting and hookup to get the bot ready for our open house event. Thanks for the feedback!
|
|
#5
19-03-2010, 10:58
|
||||
|
||||
|
Re: pic: 1671 Electronics Board (90%)
Looks great.
Thanks Kent you have really helped our electronics team out this year. We really appreciate it. 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Electronics Board | Team2339 | Extra Discussion | 1 | 15-01-2009 19:31 |
| pic: 1902 Electronics Board | Sayrah | Extra Discussion | 3 | 09-02-2008 16:42 |
| pic: Top of electronics board | keenanmolner | Extra Discussion | 4 | 19-02-2007 00:57 |
| pic: Side of electronics board | keenanmolner | Extra Discussion | 1 | 18-02-2007 20:15 |
| pic: 1023 Electronics Board | KTorak | Robot Showcase | 1 | 13-02-2006 21:57 |
Linear Mode
