|
|
|
 FIRST is a pretty decent microcosm of real life,
those who work hard, accomplish more
decent lesson to learn, and FIRST is allowing us to learn it. - Aren_Hill [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is a pretty decent microcosm of real life,
those who work hard, accomplish more
decent lesson to learn, and FIRST is allowing us to learn it. - Aren_Hill [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Andymark Hex Bearing Trouble
Has anyone else had any issues with the 3/8" Hex bore bearing from Andymark? (p/n am-0439)
I'd like to here about both successful and unsuccessful implementations. I'll start with my experience: 4 total Bearings supporting 2 winch drums. Half of the bearings were standard 3/8" ID flanged shielded, the other half were the AM 3/8" Hex. Both hex bearings' inner races were destroyed. The -static- load on the system never exceeded 160 lbs. IMHO there was no more than slight, if any at all, dynamic loading due to system configuration. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bearing Blocks | Matt382 | Technical Discussion | 4 | 29-01-2008 22:30 |
| Trouble: AndyMark Mecanum wheels | bbr4d3r | Technical Discussion | 6 | 28-01-2008 20:27 |
| Inventor software trouble/ FIRST Base trouble | nasa-senpai | General Forum | 2 | 24-01-2007 09:15 |
| Bearing problem | Templar1396 | Technical Discussion | 2 | 20-01-2007 13:08 |
| Bushing v. Bearing | VinceT | Technical Discussion | 14 | 22-12-2003 19:11 |
Threaded Mode